I'm not very experienced with configuring network devices to this depth so please ELI~10. Even moreso I *think* I should maybe find the port forwarding firewall rules and modify those to only allow from that specific source IP instead of adding a seperate rule to drop anything to those ports that isn't the source IP.Įverything I've done so far has been via the WebUI - I'm comfortable working in a CLI if I know what I'm doing.Īny advice would be much appreciated. I think that is what I should do instead but I'm wary of invoking another factory reset event. I *think* I went wrong by making a new firewall ruleset and not adding to the existing and default inbound ruleset. I tried setting up a firewall ruleset which allowed only the VPS's IP as the source to the destination IP on eth4 (my WAN interface in my configuration) with a default action of drop for anything else that didn't match but this resulted in a situation where I had to reset to factory defaults as I couldn't get any traffic through. I'd like for only that VPS to be able to access those forwarded ports. if outside “cannot find page”.I'm using an ER-X at home and I've punched a few holes into the firewall for various web apps that I use so my VPS can reverse proxy to them. if i navigate from inside – it automatically redirects to https and router web page. Wow, thank you for so prompt reply! i have such configuration as below. Once detected, the tool will fetch current port forwarding entries from your router and display them for you. To configure your router, launch Port Forwarding Wizard and wait till it detects the router. Set destination group address-group ADDRv4_eth1Īlso questions: if I finally will be able to setup everything, do I need to create rule for each port forwarding? Port Forwarding Wizard communicates with your router by using the UPnP standard after enabling the UPnP option in your router. Find the Firewall/NAT tab at the top of the screen and click it. NAT configuration warning: interface eth+ does not exist on this systemĬommands that I executed (i try to setup 80 port forwarding, my internet interface is eth1, switch0 is 192.168.2.0/24, server to run web 192.168.2.10) : Find the Port Forwarding section in your Ubiquiti EdgeRouter X router. If I try to do the configuration with light modification on commit I commit and I have configured switch0 interface on three ports. I have EdgeRouter Poe (lite with 5 ports). * Finally, we create a firewall rule to allow the inbound traffic * Now we need to setup NAT Masquerading for LAN to loop back to LAN Set destination group address-group ADDRv4_eth2 The aforementioned option matches packets destined to the IPv4 address on interface eth2.// Note: my external interface is eth2, modify the `ADDRv4_eth2` to accommodate your setup. In version 1.3.0, the `destination group address-group` option was added allowing for easy dynamic NAT reflection. Note that we are using the `eth+` wildcard in order for this rule to be active on all interfaces. * Now set the destination settings of this NAT rule. * Create NAT rule the below will forward inbound port 443 to local IP 192.168.69.100 on port 443 If you are running an older version, you should use ]. This tutorial will walk you through creating a NAT hairpin for a Ubiquiti EdgeRouter Lite running at least version 1.3.0. This is useful when you run a server inside of a local network, and would like to access it using your domain name/external IP. NAT Loopback/hairpin/reflection allows internal clients to access internal resources using an external IP/hostname.
0 Comments
Leave a Reply. |